Procedure:

• Set T1 cursor position where two pattern is matched. (This is starting point.)
• Select two signals to compare.Note bit-width must be the same.
• Right-Click => Compare Waveforms

Veritak will start search from the current T1 cursor position continues toward right direction until two pattern is not matched. If no difference is found, then move to the last transition of the signals.

Result of operation;

Sort By Scope Name
"Sort By Scope Name" may be useful for detecting discrepancy between VCD signals and Veritak Result.all at once by view. Use the function above in detail comparison.for each signals.

.